TattuSKU: TA-10C-40000-6S1P-HV

Sale price$752

Shipping calculated at checkout

In stock (3 units), ready to be shipped


Tattu 10C 6S 40000mAh Lipo Battery is the most powerful battery and it is suitable for inspection and mapping drones. Tattu 40000mAh 6S 10C Lipo has Maximum capacity, super long flight time beyond known limits and stable performance at the same time set new benchmarks - Simply flying at its best! Experience the difference a quality battery makes to your aircraft's flight.

Gens Ace batteries provide high quality, reliable power for your Multirotor or Aircraft.

The TATTU 40,000MAH 6S 10C LiPO battery pack is a great choice for commercial applications and heavy-lift rigs.

NOTE: Please do not choose expedited shipping unless you live in greater Sydney as batteries cannot be shipped by Air.


  • Capacity (mAh): 40,000
  • Voltage (V): 22.8
  • Discharge Rate (C): 10
  • Configuration: 6S1P
  • Net Weight (±40g): 4130
  • Length (±5mm): 263mm
  • Width (±2mm): 122mm
  • Height (±2mm): 63mm
  • Connector Type: AS150+XT150
  • Wire Gauge: TBA
  • Wire Length (mm): TBA
  • Balance Connector Type: JST-XH
  • Charge Rate: 1C Recommended

 Lipo Battery Safety 

  • Batteries should NEVER be left unattended while charging.
  • Be absolutely sure that the Lithium Polymer charger settings are correct for the battery pack being charged – both voltage and current settings.
  • Lithium Polymer must be CHARGED and STORED in a fire-safe container like a Lipo Sack.
  • Do not charge batteries near flammable items or liquids.
  • Keep a dry fire extinguisher nearby or a large bucket of dry sand, which is a cheap and effective extinguisher.
  • Never charge inside an automobile even when parked.
  • KEEP BATTERIES AWAY from children and pets at ALL times.
  • Never discharge below 3.5V per cell as it may cause permanent damage and void warranty
  • Battery may explode if damaged or disposed of in fire
  • Never leave batteries inside a car on a hot day or any other place where temperature may exceed 140F / 60C.
  • Although environmentally friendly, lithium polymer cells must be FULLY discharged before disposal. Use a resistor setup (light bulbs, for example) to accomplish this, to avoid the possibility of a short-induced fire after disposal.
  • Immediately discharge damaged batteries at 1/2 C rate and dispose
  • Do not put the loose cells in a pocket, bag, or drawer where they could short-circuit against other items, or the battery tabs could be pressed against each other.
  • Take care that the cells are not punctured, especially by metallic objects like hobby knives.
  • If the electrolyte in the cells should get on your skin, thoroughly wash with soap and water. If in the eyes, rinse thoroughly with cool water. Immediately seek medical attention for this, or for burns.

Estimate shipping

You may also like

Recently viewed