Description
SPEEDYBEE F7 V2 Stack.
The worlds first FC with wireless firmware flasher and Blackbox analyzer.
SpeedyBee F7V2 Specifications
- MCU STM32F722
- IMU MPU6000
- USB Type-C
- Baro BMP280 (I2C)
- OSD BetaFlight OSD w/ AT7456E chip
- BLE Support, used for Flight Controller configuration
- WiFi Support, used for data transfer, e.g firmware
- flashing, and Blackbox analysis.
- DJI Air Unit slot A full DJI Air Unit JST slot onboard
- BlackBox 16MB onboard dataflash
- Current Sensor 1 : 10 (Scale 168)
- BetaFlight Camera Control Pad Yes
- Power input 3S - 6S Lipo
- 5V power output 7 * 5V output, 6 pads and a BZ+ pad used for Buzzer, the maximum load current is 2.5A. 9V * 1,
- the maximum load current is 2.5A.
- 9V power output 2 * 9V output, 1 pads and another one used for DJI slot
- 4.5V power output 1 * 4.5V output pad
- 3.3V power output 1 * 3.3V output pad, the maximum load current is 500mA.
- ESC signal M1 - M4
- UART Full UART * 5(UART1, UART2, UART3, UART5, UART6)
- ESC Telemetry UART UART4 RX
- I2C Used for external Magnetometer, Sonar, etc.
- LED pin Used for WS2812 LED
- Buzzer BZ+ and BZ- pad used for 5V Buzzer
- Boot button Used to easy enter DFU mode
- RSSI input RSSI input solder pad
- SmartPort Use any TX pad of UART for the SmartPort feature.
- Support Flight Controller Firmware BetaFlight(Default), EMUFlight
- Target name SPEEDYBEEF7V2
- Mounting 30.5 x 30.5mm, 4mm hole size
- Dimension 41 x 38 x 6.9mm
- Weight 9g
SpeedyBee BLHeli32 45A 4 in 1 ESC Specifications
- Firmware BLHeli32 SpeedyBee 4in1
- MCU STM32F051
- Continuous Current 45A * 4
- Burst Current 55A(10S)
- ESC Protocol DSHOT300/600/1200
- Power input 3S - 6S LiPo
- Power output VBAT
- Current Sensor Support (Scale 168)
- ESC Telemetry Support
- Mounting 30.5 x 30.5mm, 4mm hole size
- Dimension 41 * 45 * 6.5mm
- Weight 12.5g
Please note due to the possibility of causing heat damage when soldering, once this product has been modified and or soldered to warranty is voided.